Replacing the Pull Cord on a Husqvarna Chainsaw and Blower

The pull cord is one of the most utilized components of both chainsaws and blowers. It can wear or break eventually, but don't worry, it's simple to replace it yourself with basic tools. In this guide, we will teach you how to replace a Husqvarna chainsaw pull cord and a Husqvarna blower pull cord step by step.

Tools & Materials Needed

It is scary to change the pull cord on your Husqvarna chainsaw, but it's very easy if you just do things in the right order. In this guide, we're going to repeat the instructions shown in the video to help you change the starter rope on your Husqvarna 240 chainsaw effectively and safely.

1. Flathead screwdriver
2. T27 Torx screwdriver
3. Needle-nose pliers
4. Replacement pull cord (3.5 mm x 90 cm)
5. Lighter (to seal the cord ends)
6. Safety gloves (optional)

Step-by-Step Instructions For Replacing the Pull Cord on a Chainsaw

1. Remove the top cover: Remove the three T27 screws to remove the top cover of the chainsaw.
2. Remove the recoil starter assembly: Remove the starter housing very carefully. This reveals the pulley and spring mechanism upon which the pull cord is located.
3. Remove the old cord: In case the cord is worn out or broken, use pliers to remove the leftover piece from the pulley and the handle.
4. Prepare the new pull cord: Trim the new cord to length (about 90 cm), and melt both ends with a lighter to prevent fraying.
5. Install the cord in the pulley: Pass one end of the new cord through the pulley hole from the inside and tie with a tight knot. Wrap the cord clockwise on the pulley.
6. Preload the recoil spring: After winding the cord, wrap the pulley six turns clockwise to spring tension. Hold it in place so the spring will not come undone.
7. Pass the cord through the handle and housing: Take the end that is loose and pass it through the starter housing and out of the handle. Tie a knot to hold it in place.
8. Install the recoil assembly: Bolt the starter housing back into place and inspect the pull cord. It should pull in smoothly with firm pressure.
9. Replace the top cover: When all functions are correct, screw the cover back on to complete the job.

Replacing the Pull Cord on a Husqvarna Leaf Blower

The starter rope of your Husqvarna 125B blower can be repaired at home using basic tools whenever it breaks or becomes frayed. The guide explains how to replace the starter rope in basic steps.

Tools and Materials Needed

1. T25 Torx screwdriver
2. New starter rope (around 3.0 mm cord) with 3 feet in length
3. Lighter (for sealing rope ends)
4. Pliers or a pick tool
5. Flathead screwdriver (optional)

Step-by-Step Instructions For Replacing the Pull Cord

Final Tips

• Always make sure the cord pulls in all the way and does not slip or hang free.
• Use only top-grade replacement cords that match your tool's specifications.
• Wear gloves if needed to protect your hands while working near the spring.

Conclusion

No matter whether you have a Husqvarna chainsaw or a Husqvarna blower, being able to replace the pull cord yourself can be a real time-and money-saver; that's why we offer the best deals to get genuine Husqvarna parts for your lawn mower. With very little equipment and some time, your machine will be operating once again in no time at all.